Interface and Toolpathing
Cimco Probing Custom Cycle Builder
The Cycle Builder is a tool that enables you to create your own custom controls and extensions in addition to the built-in cycles currently available in CIMCO Probing. The Cycle Builder has been developed to fulfil the following needs for CIMCO ...
How to build 3D tools in Lathe
The video here explains the process for adding a 3D tool in Mastercam 2024. This process is essentially unchanged for several versions of Mastercam. The tool shown in the video is a relatively simple tool, but explains all the major parts of building ...
Setting up tools in Mill
This is a basic guide for setting up tools for Mastercam Mill. -Your friendly neighborhood MCAM Support Team
Could not green-check out of Machine Group Setup page.
Problem: A page inside the Machine Group Setup is showing a greyed-out checkmark and cannot continue. Cause: An incorrect value is listed somewhere in the Machine Group Setup. In this example, the issue was with the Sequence Number Increment (set to ...
Pushing the 3D limits of Mill
This video will help you understand what your 3D milling options are in the "Mastercam Mill" product, without the "Mastercam Mill 3D" upgrade. ...
How to create a Zip2Go file for Mastercam Support
Situation: Support is requesting a Zip2Go file to help with your issue. These file types give support access to information that can help diagnose the cause of problems experienced in Mastercam. Solution: Video instructions available here -Your ...